Support
If you call for support, please have the following ready:
Product:
Wireless Door-/Window Contact, magnetic
Item no.: 278002
You can also send an email to support with your question
(info@safehome.dk)
SEND EMAIL TO SUPPORT
Send me an email with the answer:
Manuals
Download ManualThere is no Quick Guide at this product
Technical Specifications
| Package Dimensions (cm) : | 22.5 x 11.3 x 3.2 |
| Package weight (gram) : | 83 |
| Dimension, sender, mm: | 80 x 40 x 15 |
| Dimension, magnet, mm: | 54 x 15 x 15 |
| Vægt, samlet, g: | 40 |
| Batterier: | 2 x 1,5 V AAA Alkaline |
| Frekvens: | 868 MHz |
- Lavt batteriforbrug
- Indikator for lavt batteriniveau
- Op til 100 m rækkevidde
- Let installering
Wireless Door-/Window Contact, magnetic
Connecting sensors and contacts for Smart Panel
Room sensor and door/window contact is factory set to operate with the panel, and no changes should therefore be made to get these works.
If you find that a room sensor or door/window contact is not communicating with the panel, we recommend you check the device indicated zone is active on the panel, and that the house code is set corresponding panel house code. If you have not changed the house code on the system, we recommend that you change this.
Zone settings:
The room sensor is factory set to zone 8.
Door / window switch is set to Zone 1.
Did you change or want to change the zone settings, you can read in the manual how to do those changes.
House Code settings:
All units is set to the same factory settings. In all sensors, panels, sirens and remotes are four "jumpers" or contacts. These can be made in either position "on" or "off".
You can then change its "house code" on all devices.
Only devices with the same "house code" can communicate. Did you change or want to change the house code in your system, you can read in the manual how to do those changes.
If you find that a room sensor or door/window contact is not communicating with the panel, we recommend you check the device indicated zone is active on the panel, and that the house code is set corresponding panel house code. If you have not changed the house code on the system, we recommend that you change this.
Zone settings:
The room sensor is factory set to zone 8.
Door / window switch is set to Zone 1.
Did you change or want to change the zone settings, you can read in the manual how to do those changes.
House Code settings:
All units is set to the same factory settings. In all sensors, panels, sirens and remotes are four "jumpers" or contacts. These can be made in either position "on" or "off".
You can then change its "house code" on all devices.
Only devices with the same "house code" can communicate. Did you change or want to change the house code in your system, you can read in the manual how to do those changes.
FAQ
OPEN I installed new sensors, but it seems like they will not communicate with the control panel?OPEN Are all the devices on battery?
OPEN How long will the batteries last?
OPEN To set the house code
OPEN My alarm goes off, although there is nothing which has enabled it
OPEN Can a sensor / sensor activate the alarm if it is running out of battery?
OPEN Is there an installation video?
OPEN Connecting sensors and contacts for Smart Panel
OPEN Test