Support
If you call for support, please have the following ready:
Product:
Wireless Siren Sensor for Gas-/Smoke-/Co2 Alarm
Item no.: 278025
You can also send an email to support with your question
(info@safehome.dk)
SEND EMAIL TO SUPPORT
Send me an email with the answer:
Manuals
Download ManualThere is no Quick Guide at this product
Technical Specifications
| Package Dimensions (cm) : | 27 x 20.5 x 3.5 |
| Package weight (gram) : | 121 |
| Dimension, sender, mm: | Ø 66 x 23 |
| Dimension, sensor, mm: | Ø 30 x 6 |
| Samlet vægt, g: | 55 |
| Batterier: | 2 x 1,5 V AAA Alkaline |
| Frekvens: | 868 MHz |
Wireless Siren Sensor for Gas-/Smoke-/Co2 Alarm
To set the house code
Make sure the house code is set to the same in all sensors and Smart Panel.
In all sensors, panels, sirens and remotes are four "jumpers" or contacts. These can be made in either position "on" or "off" - or the little jumper can be removed ("off") or put on ("on").
One can therefore change its "house code" on all devices. Only devices with the same "house code" can communicate. All units and construction is set to the same from factory, but in the manual, it is described how it changed.
In all sensors, panels, sirens and remotes are four "jumpers" or contacts. These can be made in either position "on" or "off" - or the little jumper can be removed ("off") or put on ("on").
One can therefore change its "house code" on all devices. Only devices with the same "house code" can communicate. All units and construction is set to the same from factory, but in the manual, it is described how it changed.
FAQ
OPEN I installed new sensors, but it seems like they will not communicate with the control panel?OPEN Are all the devices on battery?
OPEN How long will the batteries last?
OPEN To set the house code
OPEN My alarm goes off, although there is nothing which has enabled it
OPEN Fault alarm at low battery